From 'Capable of Handling' to 'Stable Operation': The Technical Logic of Hengli's Integrated Lithium Battery Recycling Line
Date:2026-09-30 Views:151
1. Changes on the demand side
The rapid expansion of the new energy industry has led to the simultaneous accumulation of recyclable materials at both ends: accelerated retirement of power batteries and waste electrode sheets in battery production. The complex composition of materials and large batch fluctuations have led to a shift in the procurement standards of recycling companies - in the past, it was about whether they could eat the materials, but now they focus on long-term stable operation, metal utilization, and emission compliance.
2. Whole line collaboration: Cracking the bottleneck of device splicing adaptation
In the early stages of the industry, procurement was carried out in multiple stages, and each unit was integrated. The shredding, pyrolysis, sorting, and exhaust gas treatment were provided by different manufacturers with different interfaces. After production, production capacity mismatch and working conditions were often disrupted. Hengli's native integrated whole line integrates the four major processes into a unified framework from the top-level design, making them interconnected rather than simply connected; Enterprises do not need to separately connect with multiple suppliers to obtain a complete system that adapts to their own site and production capacity.
3. Two key breakthroughs in the pyrolysis process
In response to the agglomeration, bridging, and blockage caused by the softening of the binder after the crushed material is heated, the production line adopts a "special auxiliary mechanism+intelligent discrete element simulation" strategy: a dynamic dispersing mechanism is configured at the feed inlet to stabilize the feed, and the motion laws of the material bed unloading layer and the cylinder wall retention layer are analyzed through simulation. The guide structure, furnace tube inclination angle, and speed are optimized to make the material pyrolysis time tend to be consistent. The entire line can also control the oxygen content in the furnace at PPM level, balancing metal recovery rate and intrinsic safety.
4. Environmental governance: from meeting standards at the end to reducing pollution at the source
Under the normalization of emission compliance, end of pipe treatment is no longer able to cope with fluctuations in operating conditions. The production line reduces pollution at the source and collaborates with end of pipe treatment: the pre electrolyte directional collection process significantly reduces the amount of pollutants generated in the pyrolysis process, and the subsequent exhaust conditions are more stable. A composite defense line was constructed to reduce fluoride at the source, suppress the environment, and upgrade materials in response to hydrofluoric acid corrosion caused by electrolyte decomposition. The tested furnace tube life was extended by more than three times.
5. Summary
From single point compliance to system compliance, the value center of recycled equipment is shifting towards "long-term stable operation". Hengli's entire production line utilizes process synergy to mitigate adaptation risks, process optimization to ensure output consistency, and source control to reduce environmental uncertainty, forming a green circular production carrier that can support enterprises in crossing the cycle of standardization and upgrading.
